Quality classification of fountain pen
 Apr 18, 2022|View:140

Lewis Edison of the United States applied the principle of capillary design to the role of parts-the pen tongue, which is closely matched with the tip of the pen, and then with a dropper to inject ink into the hollow shaft, relying on capillary gravity, fountain Pen is a prototype that uses ink to flow automatically to the tip of the pen. To test the fountain pen's performance, we need to do the following experiments.


fountain pen


After the ink is injected into the pen, the pen is placed upside down on the centrifuge, and the ink is flicked into the pen bladder by the centrifuge. A fountain pen without an exhaust pipe should be filled with 1/4 ink which is 30% more than the actual water absorption. Fountain Pen's fittings are flat and firm, accounting for 30% of the overall pass rate of appearance. The contents include: the parts are assembled with uneven eyes, not firm, obviously crooked, single side, the fittings are out of seam; Obvious rubbing hair, silk lines, variegated color, coating white, blistering, spots and other defects. For each fountain pen with one of these defects, 0.2% of the pass rate is deducted.


Minor defects are those which have a slight effect on the performance of the product, such as the slot of the NIB is more than 0.20 mm than the locating hole, the nib (sharp flower), the ferrule, the shedding of the Baotou, the missing tooth of the nib is less than two teeth in a third of a week, the surface defect area of the parts is equal to 2mm & SUP2; the parts are cracked by less than 3mm, the crack of the plastic parts is not more than 1mm. A heavy defect is a defect that seriously reduces the practical performance of the product. If the tip slip degree is not qualified (iridium head sand hole, iridium fragment is not more than 0.2 mm), the length of the big crack of the pen neck, the tip sleeve, and the rod sleeve is not more than 2 mm, the length of the crack of other parts is less than 5 mm, the missing tooth of the pen tongue is less than 2 teeth. Serious defects refer to those kinds of defects that are more than heavy defects and which have lost or seriously lost practical performance.

View More(Total0)Comment lists
No Comment
I want to comment
Content*
Verification code*